Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 1–6 Introduction
The System Controller is configured with a subset of the following
hardware:
• Hardware (cards): The cards that are installed in the
System Controller are standard plug–in type CPU cards that
are ISA or PCI compatible. The System Controller has eight
ISA slots and nine PCI slots. The following cards are
installed in the System Controller:
- Quad T1 cards (1 minimum, 6 maximum) with four T1
ports per card
- TX2000 IP card (1)
- Conference card (0, 1, or 2)
- CD–ROM SCSI card (1)
- 56K modem card (1)
- Ethernet cards (1 or 2)
- Optional: TX2000 SS7 card (1)
• Hardware (System Controller components)
- Keyboard with integrated touchpad
- Passive backplane supporting 8 ISA, 9 PCI, and
PICMG single board computers
- 512 MB PC100 error correcting synchronous DRAM
- 10/100BaseT PCI ethernet card
- 56K V.90 X2 modem, ISA bus
- 8.4 GB Ultra ATA hard drive (minimum, connected to
IDE interface number 1)
- 1.44 MB floppy drive
- CD–RW drive with SCSI interface (2X write mode, 6X
read mode minimum, installed in ISA slot 7)
- VGA monitor allowing a minimum of 640x480
resolution (optional)
- standard EIA 19 inch equipment chassis
The System Controller includes the following software:
- Windows NT computer
- Oracle database software
- System Controller and OMC software on CD–ROM
- Computer–based Training (CBT – available as a
separate CD–ROM)
- Online PDF documentation (available as a separate
CD–ROM)
Software