Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Updating software; backing up databases D–3
To restore the databases from a CD to the Controller hard disk:
1. Enter these commands from a DOS prompt:
cd %omc_root_dir%\tools
cleanupdb
The cleanupdb script closes all AROS processes and
cleans the databases. After some time, the Controller
reboots itself, but no AROS services start.
2. After the Controller reboots, enter:
cd %omc_root_dir%\tools
restore <CD–ROM drive letter>
The Controller reboots again.
3. Launch the AIReach Office application and verify that the
database has been restored. Check the NSS, HLR, MSC and
systemwide configurations.
Restoring