Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
C.2
1026209–0001 Revision B
Equipment part numbers C–1
Appendix C
Equipment part numbers
This appendix lists part numbers for major components of the
AIReach OS:
• Customer documentation – page C–1
• Component part numbers – page C–1
For document numbers for AIReach OS customer documents, see
the About section of this manual.
Table C-1 lists the major components of the AIReach OS, field
replaceable units (FRUs), parts needed for installation, and their
part numbers.
Table C-1 Major AIReach OS components,
FRUs, and installation parts
Component
HNS part number
System Controller and major components
AROSC System Controller with 1 Quad T1 card, 1 TX2000 IP card,
1 LAN card, and 1 conference card
1028007–0001
CD ROM drive, read/write, internal 9010029–0001
Hard drive, 8.4 Gb 9010025–0001
Floppy disk drive, 3.5 inch, 1.44 Mb 9010028–0001
TX2000 IP card 9010089–0002
TX2000 SS7 card 9010089–0001
Quad T1 card 9010087–0001
Conference card 9010086–0001
Ethernet 10/100 LAN card 9010111–0001
Modem, V.90/56K voice/fax ISA 9010027–0001
System Controller installation parts
MVIP to H.100 adapter card 9010118–0001
Short MVIP assembly for 1 Quad T1 cards 1028010–0002
H.100 ribbon cable (For Quad T1 cards), with 68–position CHAMP
connector
1028158–0001
C.1
Customer
documentation
Component part
numbers