Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Maintaining Quad T1 card 14–3
11. If the removed card was the first in a chain of Quad T1
cards, an MVIP–to–H.100 bus adapter card is attached at
the top of the Quad T1 card (Figure 14-1): Unscrew the bus
adapter card (or use a new bus adapter card) and connect it
to the new Quad T1 card, as shown in Figure 14-2.
The bus adapter card must be secure and in full contact
with the Quad T1 card.
Figure 14-2 MVIP bus adapter card (on the first Quad T1 card)
G-17195 F
09/30/99
Secure adapter card with No. 4
screw into Quad T1 card
Insert bus adapter
connection into
Quad T1 card
MVIP bus connector
H.100 bus connector
2.
1.
12. Insert the new Quad T1 card into the slot where the original
card was removed.
Press down carefully to seat the card in the motherboard
connector. Be especially careful if a bus adapter card is
attached to the Quad T1 card.
13. Insert and tighten the hold–down screw removed from the
original card.
14. Reconnect the H.100 cable to all Quad T1 cards. Refer to
Figure 14-1.
15. If the card replaced is the first card in a chain of Quad T1
cards, carefully reconnect the MVIP cable. See Figure 14-1.
16. Reconnect any PBX or BTS cables to the back of the card.
17. Replace the Controller cover.
Be careful not to damage the copper finger stock under the
front edge of the cover.