Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Maintaining Quad T1 card 14–1
Chapter 14
Maintaining Quad T1 cards
This chapter includes the following topics:
• Replacing a Quad T1 card – page 14–2
• Moving a Quad T1 card – page 14–5
• Removing (deleting) a Quad T1 card – page 14–9
To add a Quad T1 card, see Sections 2.4 through 2.8.
The instructions in this chapter are not part of the initial
installation procedure. They are provided in case you need to
replace, move, or remove a Quad T1 card.
If you need to replace, move, or permanently remove (delete) a
Quad T1 card, you must exercise special care because specific
instructions for DIP switch settings, an adapter card, and bus
cables depend on the slot where the card is installed (or removed
from).