Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Troubleshooting 13–7
Phones do not lock or register
If the phones do not lock or register, check:
• The phone programming
• The subscriber entries on the provisioning screens
• The DCCH configuration
Mobile phones cannot contact each other
If two mobile phones cannot call each other, check:
• The PBX connection LED on the rear of the System
Controller.
• That the PBX administrator has activated the T1 and
entered the phantom numbers correctly.
• That all cells are listed under MSC Configuration, BSC
Configuration.
• The dialing plan in the configuration information. Make
sure the information has been entered correctly.
Coverage and handoff problems
Call TAC in case of:
• Bad signal strength
• Dragging calls
• Frequent handoffs
• System Controller cutoffs
• Signal strength outside the building