Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 9–2 System testing
To complete installation of the AIReach OS, conduct performance
tests as follows:
1. Obtain the Performance Test Checklist from your AIReach
OS Program Manager.
2. Complete this checklist by performing each listed test and
checking the associated box after each test is successfully
completed.
Note
A customer representative should witness the performance
tests.
3. Sign the completed checklist.
4. Obtain the customer’s representative’s signature.
5. Send the completed Performance Test Checklist to the HNS
Installation Manager.
6. Correct the Configuration Report to reflect the “as–built”
AIReach OS installation.
7. Correct (red line) the Configuration Report to reflect the
“as–built” installation.
8. Copy the AIReach OS default.cfg file to a floppy disk.
To find the AIReach OS current release directory, which
contains default.cfg, enter:
cd %AROS_Root_Dir%
from the DOS prompt.
9. Send the corrected Configuration Report and default.cfg
floppy disk to the HNS Installation Manager.
9.2
Performance testing