Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B xvi Important safety information
This manual includes the following safety warnings:
WARNING
When installing the picocell on the mounting
plate, use care to avoid falling and injuring
yourself.
WARNING
The AIReach Office System Controller can
weigh in excess of 50 pounds. To avoid
personal injury or damage to equipment,
follow these precautions:
• Do not attempt to move or install the
System Controller by yourself. Two
people are required for these tasks.
• If the System Controller will be rack
mounted, secure the rack to the floor
or wall so the rack cannot fall.
WARNING
The AIReach Office System Controller can
weigh in excess of 50 pounds. To avoid
personal injury or damage to equipment,
follow these precautions:
• Do not attempt to move or install the
System Controller by yourself. Two
people are required for these tasks.
• Do not stack more than three System
Controller boxes.
Warnings used in this
manual