Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Connecting to external equipment 8–15
Table 8-1 Supported alphanumeric
service providers
Provider/service name Provider ID
TNI Paging 800 TNI800
Touch Tel Paging 510 TTP510
US West 520 USW520
Westlink Paging 602 WLP602
Westlink Paging 801 WLP801
1
For SKYTEL alphanumeric users who have a
pin number instead of an 800 number, the
dialup number will be 1–800–679–2778. (See
Creating a new provider ID
below.)
Required for numeric pagers:
PagerType numeric
ServiceNumber <service provider phone
number>
PIN <operator PIN>
Required for beepers:
PagerType beeper
BeeperNumber <beeper number>
Required for alphanumeric mobile phones:
pagerType alpha
serviceProvider <provider ID>
min <operator MIN>
Required for numeric mobile phones:
PagerType numeric
ServiceNumber <service provider phone
number>
MIN <operator MIN>
Sample entries for ArosPageInfo.dat:
Sample entries for alphanumeric Skytel pager
with PIN number 8863647:
pagingEnabled yes
pagerType alpha
perviceProvider SKYTEL
pin 8863647