Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Connecting to external equipment 8–5
1. Copy the <WOSC Certificate Follows> block of
information, starting with (and including) the header
––––BEGIN CERTIFICATE––––
and ending with (and including) the footer
––––END CERTIFICATE––––
2. Paste the block just copied at the beginning of the
spst.key file created in step 3 on page 8–4.
3. Save the modified spst.key file created in steps 1 and 2
above as spst_c.pem.
4. Open the file spstca.pem.
5. If the CA certificate has already been installed—that is, if
<CA Certificate Follows> is already included in
the file, as shown in Figure 8-1, proceed to the next section,
Installing the certificate.
6. If the CA certificate has not been installed, follow these
steps:
a. Copy the <CA Certificate Follows> block
of information, starting with the header
––––BEGIN CERTIFICATE––––
and ending with the footer
––––END CERTIFICATE––––
b. Paste the block just copied at the end of the
spstca.pem file.
Note
The CA certificate may already be included in the
spstca.pem file.
c. Save the modified file created in steps a and b as
spstca.pem.