Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Installing picocell 7–11
Figure 7-7 T1 cabling for standalone and daisy–chained picocells
T0001009
VOICE/
DATA
OUT
VOICE/
DATA
IN
Power
switch
VOICE/
DATA
OUT
VOICE/
DATA
IN
Power
switch
VOICE/DATA OUT
VOICE/DATA IN
VOICE/DATA OUT
VOICE/DATA IN
VOICE/DATA OUT
VOICE/DATA IN
Telco blocks
Picocells
CAT 5 T1 cabling
(single run)
To
Controller
CAT 5 T1 cabling
(double run)
VOICE/DATA OUT
VOICE/DATA IN
VOICE/DATA OUT
VOICE/DATA IN
VOICE/DATA OUT
VOICE/DATA IN
Telco blocks
Picocells
To
Controller
Standalone picocells
Daisy-chained picocells