Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209â0001 Revision B 7â10 Installing picocell
4. Connect the T1 cable (with RJâ45 connector) to the
appropriate picocell port, as shown in Figure 7-6.
LINE I
OFF
o
LOCAL I
VOICE/
DATA
OUT
VOICE/
DATA
IN
(LINE POWER)
F
U
S
E
LOCAL -
POWER +
T0001010
Picocell
Line
power
Local
power
Local power
(not used)
Connect CAT 5 T1 cable
here for
picocell.
daisy-chained
Connect CAT 5 T1/power
cable here for both
picocells.
standalone and daisy-
chained
Power switch
Figure 7-6 T1 cable and power connections at the picocell