Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 7–2 Installing picocell
The picocell is designed to be attached to different wall surfaces:
wallboard, concrete, wood, or metal or wood studs.
The mounting plate must have at least 4.5 to 5. inches of clearance
on all sides (from ceiling, floor, and walls) so the picocell will
have proper clearance (3 inches minimum) for mounting and
ventilation. See Figure 7-1.
4.5"
4.5"
4.5"
5"
The clearances shown above allow a 3-inch minimum clearance
on the sides and top of the picocell, when it is mounted.
Ceiling
Wall
T0001025
Mounting plate
Figure 7-1 Placing the mounting plate to allow proper clearance around the picocell
7.2
Mounting the
picocells
Installing the mounting
plate