Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 6–28 Testing picocells
To initialize changed settings for a Nokia series 6000 phone:
(You do not need to do these steps after putting the phone into
field test mode and entering the MIN.)
1. Power off the cellular phone and then turn the power on.
2. Press
(Menu) to display the menu.
3. Press
or until Setting displays and press .
4. Press
until Network Services displays.
5. Verify that digital & analog displays.
6. If digital & analog does not display, press
until digital
& analog displays and press
.
7. Press
until Public System displays and press .
8. Press
until Any System is highlighted and press .
9. Press
(right button) until the main screen displays.
10. Press
until System displays and press .
11. Highlight New Search and press
.
12. Verify that Alpha Tag displays and press
.
Initializing settings