Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 6–26 Testing picocells
The following programming procedures for Nokia Series 6000
mobile phones are provided for the installer’s convenience.
However, normally, these procedures are not required to complete
and test the installation.
To program the home system ID number for a Nokia 6000 series
mobile phone:
1. Enter *3001#12345#.
2. Press
until Field Test displays, then press .
3. Press
until Enabled is highlighted and press (OK).
4. Press
until NAM1 is highlighted and press .
Verify Home System ID displays 13.
5. If 13 does not display, press
, enter 13 and press .
To program the Home SOC for a Nokia series 6000 phone:
1. Press
until Home SOC displays. Verify that the Home
SOC displays 4.
2. If the Home SOC is not correct, press
, enter 4, and
press
.
To program the PSID/RSID number:
1. Press
until PSID/RSID displays and press .
2. Select
P/RSID 1.
3. Press until the PSID/RSID displays. Verify that 15099
displays for the PSID.
4. If the PSID is incorrect, press
, enter the PSID 15099,
and press .
To program the system ID number for a Nokia series 6000 phone:
1. Press
until the System ID displays and press .
2. Verify that the System ID displays 13.
3. If the System ID is incorrect, press
, enter 13, and press
.
6.10
Additional phone
programming
procedures
Home system ID
Home SOC
PSID/RSID number
System ID number