Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 6–22 Testing picocells
18. Click the Operational Status tab.
19. Verify that the specified HLR Flags and VLR Flags are
displayed.
The next step (detailed in Section 6.9) is to place test calls to test
the picocells. However, before phones can be used for testing, they
must be programmed for the customer system, as explained below,
and then registered (as explained in Section 6.8).
Installers use Nokia 6120, 6160, or 6161 mobile phones to test the
AIReach OS. To program a Nokia series 6000 mobile phone for
testing, follow the steps below. All other necessary values are
loaded when the phone is registered onto the AIReach OS.
1. Enter *3001#12345#.
2. Activate field test mode:
a. Press
until Field Test is highlighted.
b. Press
(OK).
c. Press
until Enabled is highlighted.
d. Press
.
3. Enter the assigned MIN:
a. Press
until NAM1 is highlighted.
b. Press
.
c. Press
until Own Number is highlighted.
d. Verify that the MIN displayed is the correct MIN.
e. If the displayed MIN is not correct:
i. Press
.
ii. Enter the correct MIN
iii. Press
.
6.7
Programming test
mobile phones