User's Manual

14 Hughes 9350 BGAN Terminal User Guide
PDP C ONTEXTS
The PDP Context page allows the User to setup and configure PDP contexts for any TE that is
connected to the UT. To activate a PDP Context, go to the bottom of the page. You will see
the CID, Local IP Address, APN, Requested QoS, Username and Password fields.
1. CID: The CID of each context is automatic by default. If for some reason the User wants to
assign a particular context to a specific CID, use the drop down arrow and select the
wanted CID number. Most users will not need to change this field from the automatic
default setting.
2. Local IP Address: This is the local IP address of the TE that you want to setup a PDP context
for. Note that the first three octets of the IP address will reflect any changes made in the
setup screen to the UT local IP address. NOTE: The field will default to the IP address of your
TE. You can change the IP address if you wish to configure a PDP context for another device.
3. APN name: This field is configurable, but it will always show the default APN that has been
provisioned on the USIM. If you have a USIM that has been provisioned with multiple APN’s,
you can type in any of these secondary APN names as part of the PDP context setup.
4. Requested QoS: The drop down list shows all of the different QoS types: background,
streaming 32K, streaming 64K, streaming 128K, and streaming 256K. Select the appropriate
QoS required for the PDP context that you are setting up. Note: Maximum QoS rate for C10 is
256K at elevation angles > 45 degrees; maximum QoS rate for C11 is 128K.