User's Manual

12 Hughes 9350 BGAN Terminal User Guide
take the Network/UT to update the TE with the correct DNS servers for web browsing after
establishing a PDP context.
5. Connected-mode DHCP Lease Time: The Connected-mode DHCP Lease Time refers to the
DHCP lease time when the UT is connected to the network. Most Users will have no need to
change this parameter.
6. PIN and PUK: The PIN and PUK fields indicate whether the PIN or PUK needs to be entered to
unlock the terminal. When grayed out they indicate the PIN is not required or is already
satisfied.
7. Bypass Antenna Pointing: This parameter allows the User to bypass antenna pointing and
have the UT go straight into Registering with the Network. This is turned “on” as default for
the 9400 Series.
8. 24/7 PDP Keep Alive: This is setting is for keeping a PDP context alive indefinitely. Note: This
parameter should not be checked unless you have a need to keep the PDP context alive for
critical information. This is not a good use of satellite resources.
9. Satellite Selection: This parameter is used within a satellite overlap region and allows the user
to override the default satellite (selected based upon elevation angle/GPS location) and
select a different satellite. Note: This change does not take effect until the UT is reset. When
set to AUTO the UT will select the satellite based on the unit’s GPS position. When set to a
specific satellite it will attempt to use that satellite only. Be careful to select the correct
satellite for your position.
10. Net mode: This option is grayed out and is set to NAT mode.
11. Streaming Inactivity Timer: This allows the user to turn on a timer for inactivity for a Streaming
QoS that has been setup. The timer is in seconds and will tear down a streaming context
after X seconds of inactivity.
12. Emergency Call Numbers: Allows the User to add the emergency call number that is
applicable in the part of the world where the terminal is being used, if it is not already
defined.
13. Apply, Cancel, and Restart Terminal buttons: These buttons are self explanatory.