User's Manual

Hughes 9350 BGAN Terminal User Guide 11
S ETUP P AGE
The Setup page allows the User to configure various parameters of the UT. A description of each
item on the page follows:
1. Terminal Local IP Address: This allows the User to change the local IP address of the terminal
from the default 192.168.128.100 IP address. Only the last two octets are available to
change. Once the local IP address is changed on this page and applied, the IP address
ranges for the DHCP server, the PDP Context page and ACA page will also be changed
automatically. Note: Updates to this field will not take effect until the UT is rebooted.
2. DHCP Server: allows the DHCP server in the UT to be turned on or off
3. DHCP Address Range: This allows the User to set the range of DHCP addresses that are given
out by the UT to any connected TE.
4. Idle-mode DHCP Lease Time: Idle-mode DHCP Lease Time refers to the DHCP lease time
when the UT is not connected to the network. This parameter allows the User to change the
default time (60 seconds) that the DHCP lease to the TE is good for. This parameter was
introduced because of a problem with some models of Cisco routers that will not accept a
short DHCP lease time. Note: The longer the Idle-mode DHCP lease time, the longer it will