User's Manual

6 Hughes 9350 BGAN Terminal User Guide
C ONNECTING BY E THERNET
To connect the BGAN terminal to a device using Ethernet:
• Connect an Ethernet cable to your device’s Ethernet port, and insert the other end of
the connector into one of the four Ethernet ports on the 9450 IDU. These four Ethernet
ports support Power-over-Ethernet (PoE).
C ONNECTING BY WLAN
If you have not previously used the IDU’s WLAN interface, it has to be enabled from the internal
web MMI or LaunchPad with your computer connected to the IDU using either the Ethernet
interface.
As you are configuring the WLAN, you can enable the Wireless Encryption Protocol (WEP), MAC
address filtering and no broadcast SSID features for added security.
Once the WLAN is turned ON and configured, any device with a WLAN interface can detect the
IDU’s WLAN SSID, and connect to it automatically.
Note: If WEP is enabled, you must provide other WLAN users with the proper WEP key in order for
them to connect to the IDU.
C ONNECTING BY ISDN
Connect an ISDN cable to your computer’s or phone’s ISDN port, and insert the other end of the
connector into the Terminal’s ISDN port.
To dial, prefix the international number with 00 and terminate with #. For example, to dial a
number in the USA, enter: 0018005551234#
To receive incoming calls you must configure your ISDN device with the MSN (Multiple Subscriber
Number) of the service it supports. See the ISDN section for information on configuration of MSNs.
To configure the MSN in your ISDN device, refer to the user guide of your ISDN device.