User's Manual

Hughes 9350 BGAN Terminal User Guide 3
G ETTING S TARTED
I NTRODUCTION TO G ETTING S TARTED
This guide is the simplest and quickest way to connect to the BGAN network. If you are a first
time user, you will be guided through the procedure for powering up your terminal, obtaining a
GPS fix, connecting your computer to the terminal and registering with the BGAN network. You
are then ready to start using voice and broadband services.
I NSTALLING Y OUR T ERMINAL
Install the Hughes 9400 Series terminals according to the Installation Guide P/N 3004129 supplied
with the terminal. Please refer to the Installation Guide for grounding instructions.
T ERMINAL LED F UNCTIONALITY
The 9450 IDU has 4 LEDs with the following functions:
Power: Green when IDU is powered on. Off when IDU is powered off. This LED is integrated
in the On/Off switch.
Network Registration: Green when registered and attached with Inmarsat BGAN network,
Off otherwise.
GPS: Green when valid GPS fix acquired since last power-cycle, off otherwise.
H/W Fault: Red if HW fault detected, e.g.: IB fault, no communication to antenna or no
GPS. Off otherwise.
Network Registration
Valid GPS Fix
HW Fault
Power On/Off
The 9450 IDU has a 4X RJ-45 connectors with 2 LEDs for each connector with the following
functions:
Green/Red bicolor: Green indicates Link active, Red indicates power over Ethernet PD
device is connected and being powered by IDU. When both LEDs are active, it will
appear Orange in color.
Yellow: Traffic indicator