User's Manual

 Using the Hughes 9
Revision 0.2
37
Information and Support
Terminal Information
Model: this displays the UT model number.
Class: this indicates the UT Class, such as Class 11
for a land mobile terminal or Class 10 for high gain
land mobile terminal.
IMEI: This displays the IMEI (serial) number of the
UT.
Software Version: This displays the current version
of software that is running on the UT.
SIM Information
IMSI: This displays the IMSI number of the SIM card
in the UT. If is the IMSI is not displayed, it indicates
that there is a problem reading the SIM card, e.g.
because there is no SIM, it is installed incorrectly or
PIN must be entered.
Default APN: This is read directly from the SIM card.
Terminal Support – contact information retrieved from the
SIM card.
Website
Telephone
E-Mail
Troubleshooting
Terminal Log Files: This allows you to extract and save any
of the following log files for troubleshooting purposes:
System Log
Event Log
Packet Log
Circuit Log
These files can be e-mailed to Hughes directly for
fault analysis if the user experiences any problems.
Reset Terminal to Factory Defaults: Clicking the ―Restore
To Defaults‖ button will restore the UT back to the factory
default settings and delete any of the user parameters that have
been set-up in the UT.