User's Manual

 Using the Hughes 9
Revision 0.2
15
Manage Connections
Manage Connections page under the Data tab allows the user to
setup and configure PDP contexts (data connection) for any TE
that is connected to the UT. It also shows you all current Active
Connections.
Open a New Connection - To open a new connection, enter the
required data in the lower box.
Owner – Your current IP address is shown by default (.101), but
you can change it to control connections for any other device
connected to the terminal. The page automatically displays
entries for all detected devices and these entries can be selected
to activate connections for those devices.
Service - Select the service that you want by clicking on the
down arrow. The drop down list shows all of the different QoS
types: standard, streaming 32K, streaming 64K, and streaming
128K. Select the appropriate service required.
APN - The APN is read from the SIM card, but if you have other
APN‘s defined (go to Manage APN page), you can use the down
arrow to select a different APN. Once everything is defined