User Manual

50 BGAN Terminal User's Guide
 This LED is not lit during Power-Up or if the Wireless LAN card is
turned off.
 It is green if Wireless LAN is on and Wireless Encryption Protocol
(WEP) is enabled (encryption).
 It is red if Wireless LAN is on and WEP is disabled.
 If Wireless LAN is enabled and the MT is operating off battery
power, the LED flashes at 1/8 duty cycle 1-second period to
save power, after the unit exits pointing.
GPS LED
The GPS unit in the Satellite Terminal will attempt to get a 3D fix each
time the unit powers up. The GPS LED indicates the state of the GPS
fix. See Obtaining a GPS Fix section.
A
UDIO BUZZER
An audio buzzer is used to indicate the signal quality during antenna
pointing. If the Audio buzzer is on, the tones act like those of a
Geiger counter: a long time between tones if the signal is weak and
a faster rate of tones as the signal is acquired.
The buzzer will always default to off when the unit powers on.
Pressing the Audio button in pointing mode turns the buzzer on.
Pressing it again turns the buzzer off. Once you exit pointing, the
buzzer will turn off. If the Audio button is pressed when the unit is not
in pointing mode, it will have no effect.