User's Manual

Thuraya IP+ Satellite Modem User Guide 21
3500799-0001 rev A
WLAN CONFIGURATION SCREEN
The WLAN Configuration Screen allows you to configure the integrated WLAN
Access Point (AP) which can support up to eight simultaneous clients using
802.11b/g/n. The WLAN AP operates on its own subnet and utilizes its own DHCP
server. The wMMI remains at 192.168.128.100 (default) whether accessed via WLAN
or Ethernet.
WLAN Power
: Select ON or OFF to turn the feature on or off.
WLAN Power Off timeout
: If disabled, there is no timeout. If this parameter is
enabled, the WLAN will remain powered up for the selected timeout value after the
terminal powers on. If no WLAN activity is detected during the timeout, the WLAN
card will power down.
WLAN SSID
: The WLAN network ID (SSID) can be entered as desired.
WLAN Region
: Select the WLAN region from a drop down list (X10, X20, X30, X31,
X32, X40 and X41). If you try to activate a channel not supported in the selected
region, the request shall be rejected with an error message.
WLAN Channel
: Select the WLAN channel from a drop down list.
WLAN Local IP Address
: The WLAN network uses the default subnet of
192.168.129.xxx with DHCP addresses starting at 192.168.129.100. The two least
significant octets can be changed to different values; however, the WLAN subnet must
remain distinct from that used by Ethernet.