User's Manual

8 Thuraya IP+ Satellite Modem User Guide
3500799-0001 rev A
STATUS/MENU DISPLAY
The upper level of the LCD displays status messages and menu items. Status messages
are summarized in the table below.
Display Description
Powering Off Displayed while Thuraya IP+ is powering down
Fault {code} A hardware fault exists, preventing operation (see
troubleshooting section for code explanations)
Too Hot A temporary thermal shutdown is about to occur
Battery Hot A temporary thermal shutdown is about to occur due to
battery heating
No SIM No SIM is detected in Thuraya IP+
Locked A security code is needed (entered via wMMI)
PIN A SIM pin code is needed (entered via wMMI)
Pointing In pointing mode
GPS old GPS is older than the system time period allows
Disconnected The terminal has no IP connection to the network, preventing
data transfer
Acquiring The terminal is attempting to connect to the network
Tx{rate}/Rx{rate} Transmit and Receive streaming rates in kilobits per second
Standard Best efforts quality of service in both directions
NAVIGATION OF THE IMMI
You navigate among the options available in the iMMI by utilizing the Menu and Modify
buttons. With the unit in its “normal” state displaying status indicators, you press the
Menu button to view and modify Quality of Service (QoS) settings and LCD display
parameters. Pressing the Modify button within a Menu option allows you to change
the current setting.
The status display is the default display; after 30 seconds of inactivity, the display
always reverts to the status display. Pressing the Menu button takes you through a
circular list of menu items and then back to the status display. The two major menu
options are the following:
Change Rate
: Modify the QoS settings for Transmit and Receive.
LCD Contrast
: Modify the contrast on your LCD.
DATA RATE SELECTION
 With the unit in the default status display, press the Menu button. The
Change Rate menu option is then displayed.