User Manual
Table Of Contents
- Safety Information
- Table of Contents
- Introduction
- First Time Setup
- Unpacking
- Minimum System Requirements and Software Installation
- Launch Pad -- QuickStart Wizard
- QuickStart Wizard Overview
- Step 1: Unpack the Satellite IP Modem
- Step 2: Unpack the Satellite IP Modem – Power
- Step 3: Connecting the Satellite IP Modem to your PC
- Step 4: Connecting Using USB
- Step 4: Connecting Using Ethernet
- Step 4: Connecting Using Bluetooth
- Step 5: GPS Location
- Step 6: Rough Pointing to Satellite
- Step 7: Rough Pointing to Satellite
- Step 8: Rough Pointing to the Satellite ( Compass Direction
- Step 9: Rough Pointing to the Satellite – Antenna
- Step 10: Fine Pointing to the Satellite
- Step 11: Fine Pointing to the Satellite
- Step 12: Exiting Pointing Mode
- Quick Reference
- Troubleshooting
- Glossary
- Index
(poor signal strength) to amber (better signal strength) to green (best signal
strength) as the antenna is manipulated to get the optimum signal.
;
Note
When the Satellite IP Modem is on battery power (no AC Mains) the
Power, Interface, and Battery Lights will flash to conserve power.
SATELLITE IP MODEM ANTENNA PROTRACTOR
When you are positioning the antenna during the
Antenna Pointing process, the protractor provides
the current angle of the antenna so that you can
adjust it to the Antenna Angle specified on the
pointing screen.
COMPASS
Reference the compass during the Antenna Pointing process to get
the correct Compass Direction needed for the antenna. The
illustration shows an example of a South-West orientation.
;
Note
The compass can be affected when close to magnetic fields or
metallic objects.
Regional BGAN Satellite IP Modem User Manual
17