User Manual
Table Of Contents
- Safety Information
- Table of Contents
- Introduction
- First Time Setup
- Unpacking
- Minimum System Requirements and Software Installation
- Launch Pad -- QuickStart Wizard
- QuickStart Wizard Overview
- Step 1: Unpack the Satellite IP Modem
- Step 2: Unpack the Satellite IP Modem – Power
- Step 3: Connecting the Satellite IP Modem to your PC
- Step 4: Connecting Using USB
- Step 4: Connecting Using Ethernet
- Step 4: Connecting Using Bluetooth
- Step 5: GPS Location
- Step 6: Rough Pointing to Satellite
- Step 7: Rough Pointing to Satellite
- Step 8: Rough Pointing to the Satellite ( Compass Direction
- Step 9: Rough Pointing to the Satellite – Antenna
- Step 10: Fine Pointing to the Satellite
- Step 11: Fine Pointing to the Satellite
- Step 12: Exiting Pointing Mode
- Quick Reference
- Troubleshooting
- Glossary
- Index
STEP 1: UNPACK THE SATELLITE IP MODEM
1. Unpack the modem and accessories. Battery,
AC mains power adapter, USB and Ethernet
cables are included with the modem.
2. Your service provider will have provided a
SIM and configuration instructions separately.
3. Insert SIM in SIM holder, then insert the SIM holder into
the modem as shown below.
STEP 2: UNPACK THE SATELLITE IP MODEM – POWER
1. Insert Battery after the SIM has been installed.
2. Plug in Power cable and charge the battery for 3 hours.
6 Regional BGAN Satellite IP Modem User Manual