User Manual

1.4 SYSTEM POWER REQUIREMENTS
There is only one power source connector for the entire TMG. This must be connected to a +12 VDC
power supply.
Power requirements are shown below:
Table 1 System Power Requirements
Voltage Input Minimum 11VDC
Voltage Input Maximum 16VDC
Total Current for TMG and Antenna 2.5A
Required Fuse 5A
Table 2 Power Cable Requirements
Cable Color Description Wire Gauge Max Length
RED +12VDC 14AWG 20 ft
BLACK Ground 14AWG 20 ft
YELLOW Ignition Sense 14AWG 20 ft
Figure 5 ICO MCAP UE Power Cables Package Figure 6 Three Power Cables within Package
1.5 ETHERNET AND USB PORTS
The RJ45 Ethernet port is available for interfacing with User Device (UD) via a standard Ethernet cable.
The USB port is a standard USB connector that allows the DVB-SH receiver inside the TMG to interface
with UD directly via standard USB cable.