User Manual

Figure 12 Lab Bench Power Supply Connection
2.3 SETTING UP THE TRUNK MOUNT GATEWAY (TMG)
These are the basic steps to setup the TMG and get it up and running:
Step 1: TMG Power Cable Connection
Step 2: Antenna Cable Connection to TMG
Step 3: Connecting Ethernet Cable and USB Cable to TMG
Step 4: Mounting TMG brackets in the trunk
STEP 1: TMG Power Cable Connection
1. Unpack the TMG and accessories. Open the packet with 3 wires (RED/ BLACK/ YELLOW) in
it.
2. Use a flat-head screw driver to loosen the 3 screws located on top row of the Orange power
connector.
3. Insert RED wire to the most left handed side connector and use a flat-head screw driver to tighten
the respective screw.
4. Insert BLACK wire to the midldle connector and use a flat-head screw driver to tighten the
respective screw.
5. Insert YELLOW wire to the most right handed side connector and use a flat-head screw driver to
tighten the respective screw.
6. Route and connect the yellow wire (Ignition Sense) to a switched 12V DC source, such as
ignition switch. Extended use of ignition sense in accessory position (ACC) by the end user may
lead to a discharged car battery. NOTE: Ensure that the connection is a switched source-OFF
when ignition is OFF or in start and ON only when ignition switch is in ACCESSORIES or RUN
position.