Installation Manual

1027144–0001 Draft – Revision D.01 7–14 Commissioning the RT
RT installation
Return to the IDU location to verify that the RT has acquired the
RT and then take the IDU out of Install mode:
1. Observe the LCD on the CCM to verify that the HT has
been successfully acquired.
The following display indicates that the RT has successfully
acquired the HT.
Install HT nnn
Acq Ack
nnn = HT ID
2. Use the buttons and LCD on the CCM to select Exit and
press the Enter button to take the IDU out of Install mode.
Install
Exit
Use the LCD Status option to check the status of the CCM, SSIs,
and ODU:
(You can only perform these checks after the RT’s ODU frequency
has been selected, as explained in section 7.4.)
Check the CCM status as follows:
1. Press Enter on the CCM front panel while the Initializing
screen shown below is displayed:
Initializing
Press Enter for Menu
(This screen is displayed
only after powerup or
reset, after SUDS.)
This puts the IDU into diagnostic mode. The LCD shows
the Main Menu:
Main Menu
Install
2. Use the up arrow to scroll to Main Menu / Status:
Main Menu
Status
7.6
Verifying HT
acquisition
7.7
Checking
component status
Check CCM status