User's Manual

1027144–0001 Draft – Revision D.01 4–10 Installing IFL cables
RT installation
All AIReach Broadband IFL cables must connect to a
grounded lightning arrestor (provided by HNS) at the building
penetration point, as shown in figure 4-2 (page 4–5) and
explained in this section. A single remote lightning arrestor can
be used for IFL cables for two RTs.
WARNING
To help avoid death, injury, or damage from
a lightning strike, you must install a
lightning arrestor where the IFL enters the
building.
Figure 4-5 identifies the remote lightning arrestor components.
Figure 4-5 Remote lightning arrestor components
Restraining
fitting
RF arrestor
rt033
Ground bar
Go to the roof to install the remote lightning arrestor.
4.9
Installing the remote
lightning arrestor