User's Manual

1027144–0001 Draft – Revision D.01
Installing indoor RT equipment 3–37
RT installation
Follow these steps to install an IDU FEM or EIDU FEM:
1. If a blank panel is installed in the slot where you will install
the FEM, loosen the thumbscrews on the blank panel and
remove it.
CAUTION
Always wear a new or recently tested
electrostatic discharge (ESD) wrist strap
(figure 3-27) when handling circuit
modules. Failure to use a wrist strap may
result in damage to components.
Figure 3-27 ESD wrist strap
rt063
Wrist
strap
Connect to IDU or
EIDU chassis
ground terminal.
2. Wrap the ESD strap snugly around your wrist and connect
the alligator clip to one of the ground terminals on the front
of the chassis power supply.
3. Remove the FEM from its ESD protective packaging.
Retain the packaging in case it is necessary to return the
FEM for repair.
Installing FEMs