User's Manual

1027144–0001 Draft – Revision D.01 7–18 Commissioning the RT
RT installation
Check the status of the ODU as follows:
1. Press Enter on the CCM front panel. (The CCM must be in
operational mode, as indicated by RT Enabled on the
LCD.)
The LCD shows:
Main Menu
Install
2. Use the up arrow to scroll to Main Menu / Status:
Main Menu
Status
3. Press Enter, to go to (select) the Status menu:
Status
CCM
4. Press the up arrow button twice to scroll to the ODU status
option:
Status
ODU
5. Press Enter to show the ODU status:
ODU
OK
The possible status conditions for CCMs, SSIs, and the
ODU are:
OK
Degraded
Failed
Unknown
(as explained on page 7–15)
To exit the Status menu, scroll to
Exit, and then press Enter.
If a failure is indicated for any component, replace that
component. Run SUDS again, and check the status of the new
component.
Check ODU status