User's Manual

1027144–0001 Draft – Revision D.01 7–16 Commissioning the RT
RT installation
Check the status of the installed SSIs as follows:
(Note that SSIs are not required for commissioning. They can be
installed after RT commissioning.)
1. Press Enter on the CCM front panel while the Initializing
screen shown below is displayed:
Initializing
Press Enter for Menu
(This screen is displayed
only after powerup or
reset, after SUDS.)
This puts the IDU into diagnostic mode. The LCD shows
the Main Menu:
The LCD shows:
Main Menu
Install
2. Use the up arrow to scroll to Main Menu / Status:
Main Menu
Status
3. Press Enter, to go to (select) the Status menu:
Status
CCM
4. Press the up arrow button to scroll to the SSI status menu:
Status
SSI 2
Check SSI status