User's Manual

1027144–0001 Draft – Revision D.01 6–26 Installing ODUs
RT installation
Now that the transceiver and cables are attached to the ODU,
adjust the antenna azimuth more precisely, as follows:
1. Install the azimuth adjuster as shown in figure 6-23.
The azimuth/elevation adjusters are identical. Use either
one as the azimuth adjuster or elevation adjuster. Two
adjusters are provided for installation convenience. The part
number for one adjuster is HNS 1024668–0023.
Figure 6-23 Installing the first adjuster, for azimuth adjustment
Install adjuster in
horizontal position for
azimuth adjustment.
hb038
Antenna
mount
Insert peg
into hole.
1.
Finger tighten
thumbscrew.
3.
Place clamp on rectangular arm.
(Arm detail is shown above.To move
clamp, turn adjuster bolt.)
Arm must be fully inserted into clamp.
2.
Arm
Adjuster
bolt
Note: Do not remove the adjusters until the antenna is
accurately pointed (after electronic pointing using the
voltmeter).
6.14
Finer antenna
azimuth adjustment