User's Manual

1027144–0001 Draft – Revision D.01 6–22 Installing ODUs
RT installation
3. Rotate the transceiver, making sure the transceiver’s
mounting bolts slide into the grooves in the antenna flange.
(The direction of rotation depends on the orientation of the
antenna bracket—to the right or left.) If the mounting bolts
will not slide into the grooves, loosen the bolts. See figure
6-20.
Figure 6-20 Transceiver (installed)
rt021
Rotate transceiver
counter-clockwise
Boresight
Mounting bolts must be
fully inserted in flange
grooves.
Graphic to be
updated.
4. Fully tighten the mounting bolts.
5. After tightening the transceiver, look through the boresight
to make sure the antenna is still accurately pointed at the
HT. See figure 6-20 for boresight location.