User's Manual

1027145–0001 Revision D Installing ODUs 4–27Hub installation
Follow these steps to attach the transceiver to the antenna:
1. Remove the plastic plug from the antenna waveguide and
the plastic cap from the transceiver coupling.
CAUTION
Always keep the waveguide and coupling
plugs in place when the transceiver is
detached from the antenna, to keep dust or
other contamination out.
2. Position the transceiver so the three connectors point
downward and its four mounting bolts are aligned with the
four grooves on the antenna bracket, as shown in figure
4-22.
T0006008
Transceiver
Antenna bracket (between
antenna and transceiver)
Waveguide
Antenna
Some antenna models may be smaller
than the antenna shown here.
Groove and
mounting bolt.
(Bolts are attached
to transceiver.)
Connectors
Figure 4-22 Aligning the transceiver mounting bolts
4.10
Attaching the
transceiver to the
antenna