User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–12 Installing ODUs
RT installation
Attach the antenna to the mount as follows:
1. With the radome facing the HT direction, position the
round, flat surface of the antenna bracket approximately
1 inch (2.5 centimeters) from the mast interface.
2. Rotate the antenna approximately 45° away from the HT
until the antenna bracket reliefs (curved indentations) are
aligned with the four nuts on the mast interface, as shown in
figure 6-10.
T0009027
Line of sight to HT
45
Close-up view:
Antenna bracket reliefs (4)
Relief
Antenna bracket
locking nut (1 of 4)
Antenna
bracket
Mast
interface
Figure 6-10 Rotating the antenna so the antenna
bracket can be placed against the mast interface
3. Press the antenna against the mast interface.
Attaching the antenna