User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–6 Installing ODUs
RT installation
Important: To correctly install the antenna mount, read and
carefully follow all instructions in this section (6.3) through
section 6.7.
Prepare the mount for installation:
1. Turn the fine azimuth adjuster as necessary to position the
clevis (barrel) approximately in the middle of the threaded
part of the adjuster. See figure 6-4.
This step ensures that you will be able to adjust the adjuster
as necessary in either direction.
Do not turn the nut behind the block that holds the fine
azimuth adjuster.
T0009020
Fine azimuth
adjuster
Fine elevation
adjuster
Turn to
adjust.
Do not
turn.
Clevis
Begin with clevis approximately
in the middle of the adjuster.
Figure 6-4 Fine azimuth and elevation adjusters
2. Turn the fine elevation adjuster as necessary to position the
clevis approximately in the middle of the threaded part of
the adjuster. See figure 6-4.
Do not turn the nut behind the block that holds the fine
elevation adjuster.