User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing ODUs 6–5
RT installation
The antenna mount (HNS 1029056–0005) is shipped fully
assembled. Figure 6-3 shows an exploded view to show all the
parts. However, you do not need to take the mount apart to install
it, unless you need to reverse the mast clamp. (The mast clamp is
reversible, as explained later.)
Antenna
bracket
Mast clamp
(rear part of antenna mount)
Mast interface
(front of
antenna
mount)
Mast
Mast interface - detail
Azimuth locking nuts
(2, top and bottom)
Elevation
locking nuts (2)
Antenna bracket
locking nuts (4)
Fine azimuth
adjuster
Fine
elevation
adjuster
HT direction
Mast clamp nuts (4)
T0009019
Figure 6-3 Antenna mount
The antenna mount design allows you to install and tighten the
mount and antenna and then adjust the antenna azimuth and
elevation without loosening the mount or antenna. Parts of the
mast interface move to allow these adjustments.
6.3
Preparing to install
the antenna mount