User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–2 Installing ODUs
RT installation
For conceptual reference, figure 6-1 illustrates how hub terminal
(HT) ODUs communicate with remote terminal (RT) ODUs. The
remote terminal (RT) outdoor unit (ODU) and integrated antenna
attach to a mount installed on a vertical or horizontal mast, as
shown in figure 6-2.
T0006019
Hub terminals
Remote
terminal
Remote terminal
Remote terminal
Figure 6-1 Hub ODUs communicating with RT ODUs
Note: The ODU installation instructions in this chapter are for the
typical case of an ODU mounted on a vertical mast. If the ODU is
mounted on a horizontal pipe, these instructions must be carefully
interpreted to account for the different mount and ODU position.
6.1
Introduction