User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing IFL cables 4–11
RT installation
Figure 4-8 Connecting the IFL cable to the arrestor
rt036
Location of second arrestor,
if 2 IFLs are installed.
5. Working from inside the arrestor body, use a wrench to
tighten the restraining fitting.
6. If you are installing a second IFL cable, repeat steps 1
through 5.
Attach the lightning arrestor to the penetration sleeve:
1. Slide the lightning arrestor over the sleeve, as shown in
figure 4-9.
2. Fasten the lightning arrestor to the sleeve with a screw.
Figure 4-9 Attaching the lightning arrestor to the sleeve
rt037
Slide the lightning arrestor
over the sleeve.
Attaching the arrestor
to the penetration
sleeve