User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing IFL cables 4–9
RT installation
All AIReach Broadband IFL cables must connect to a
grounded lightning arrestor (provided by HNS) at the building
penetration point, as shown in figure 4-2 (page 4–4) and
explained in this section.
WARNING
To help avoid death, injury, or damage from
a lightning strike, you
must
install a
lightning arrestor where the IFL enters the
building.
Figure 4-5 identifies the components of a typical RT lightning
arrestor. The design illustrated here (see also figure 4-6) can
accommodate one or two IFL cables for up to two RTs.
Figure 4-5 Typical RT lightning arrestor
Restraining
fitting
RF arrestor
rt033
Ground bar
Go to the roof to install the lightning arrestor.
4.8
Installing the RT
lightning arrestor