User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 7–16 Commissioning the RT
RT installation
Check the status of the ODU as follows:
1. From the Status / SSI 1 display, shown below,
Status
SSI 1
press NEXT to scroll to the ODU status menu:
Status
ODU
2. Press ENTER to show the ODU status:
ODU
OK
The possible status conditions for the ODU are:
OK
Degraded
Failed
Unknown
(as explained on page 7–14)
Note: You will not see ODU status information if the ODU
is not connected (via the IFL) to the IDU. The status will be
Unknown.
If a failure is indicated for any component, replace the failed
component. Run SUDS, and check the status of the new
component.
3. Exit the Status menu: Scroll to:
Status
Exit
and then press ENTER.
4. Exit the Main Menu: Scroll to:
Main Menu
Exit
and then press ENTER.
Check ODU status