User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 7–10 Commissioning the RT
RT installation
9. Connect a digital voltmeter to the F connector on the ODU,
as shown in figure 7-6, and select the 0 to 10 volt or 0 to 5
volt range.
Figure 7-6 Connecting the digital voltmeter to the ODU
T0009016
Digital
voltmeter
IFL
Ground
wire
Use F connector to connect
cable to (center) pointing port.
BNC connector with
banana plug
Rear view
Protective cap
for pointing port