User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–24 Installing ODUs
RT installation
T0009012
Transceiver
Antenna
Ground
point
Ground
cable
2-hole compression lug
(Shown: Bond to structural steel)
Ground point
on roof
3.
ODU
side view
Apply anti-oxidant
and heat shrink to
all ground lugs.
End view
Clamp-type ground connector.
Strip cable at clamp.
Bolted joint on
mast mount
2.
View from rear
Transceiver
Single-hole
compression lug
Ground cable
No. 6 AWG
or greater
ODU ground connector
1.
Figure 6-23 ODU grounding connections