User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D 6–16 Installing ODUs
RT installation
3. When the azimuth is properly adjusted, use a torque
wrench with a deep socket to tighten the four mast
clamp nuts to 16 foot–pounds torque (21.7 Newton–
meters). See figure 6-15. Tighten each bolt a little at a
time, moving from bolt to bolt in an X pattern.
CAUTION
Correct torque is
essential
for successful
installation and adjustment. Tighten nuts to
the exact torque stated. Incorrect torque
may result in damage to equipment.
Figure 6-15 Mast clamp nuts
T0006057
Mast clamp nuts
(Only 2 of the 4 nuts
are visible in this
illustration.)