User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Indoor equipment
- Ch 4 - Installing IFL cables
- Ch. 5 - Installing mast mounts
- Ch 6 - Installing ODUs
- Ch 7 - Commissioning the RT
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating the IFL cable
- Index
1027144–0001 Revision D
Installing ODUs 6–15
RT installation
Obtain a coarse azimuth adjustment as follows:
1. Stand behind the antenna so you can see through the
antenna boresight (shown in figure 6-13).
rt026
Boresight
Antenna bracket
Figure 6-13 Boresight location
2. Using the boresight for reference, rotate the antenna and
antenna mount horizontally around the mast (by hand, not
by using the azimuth adjuster), until you can see the HT in
the horizontal center of the boresight, with no shadow
inside the boresight to the left or right. See figure 6-14.
(You should not need to use the fine azimuth adjuster until
you point the antenna with the voltmeter.)
T0009008
Adjust
azimuth
to left.
Adjust
azimuth
to right.
Azimuth
properly
adjusted
Boresight
Figure 6-14 Using the boresight to adjust azimuth
Coarse azimuth
adjustment