User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Installing mast mounts
- Ch 4 - Installing ODUs
- Ch 5 - Installing IFL cables
- Ch 6 - Indoor equipment
- Ch 7 - Commissioning HTs
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating IFL cables
- Index
1027145–0001 Revision E 4–20 Installing ODUs Hub installation
To adjust the antenna elevation (upward or downward pointing
direction), you rotate the antenna upward or downward, as
illustrated in figure 4-15, until the elevation is set as desired.
Antenna
(front)
Side view
0 elevation°
Downward
elevation
Upward
elevation
T0006035
Figure 4-15 Antenna elevation adjustment
(upward or downward adjustment)
Adjust the antenna to the elevation angle specified in the
configuration document as follows:
1. Rotate the antenna until its elevation angle (angle from
horizontal) is approximately the same as the specified
elevation angle (typically 0° or near 0°).
If the antenna does not rotate freely, loosen each of the
antenna bracket nuts slightly.
4.8
Adjusting the
antenna elevation